TV console table – To build it, starting with design the size of your console table. This depends on the size of the TV; it must fit safely on top. Measure the space in the corner. Then decide on the number of shelves you need to hold the cable / satellite box, DVR / DVD player, video storage and any stereo. Draw the top and bottom dimensions of the console table on particleboard. These two pieces should be the correct triangles (see algebra below formulas) to fit the corner. Add as many pieces in the same shape and size for your shelves. Cut them out.
Cut four pieces the height of your TV console table from 2-of-6 discs. Tilt the boards vertically so that you can attach 6-inch sides to the edges of particleboard (the sides that will face the walls) in each corner. Screw each board into the top and bottom pieces of particleboard. Brace the top and bottom of the boards with L-brackets. Screw two fasteners on the underside of the upper and inner sides of 2-of-6 discs. Screw two fasteners to the top of the lower part, then to the inner sides of the boards.
Lay the shelves to the console to match the upper and lower pieces. Their edges facing the side boards. Position each shelf for a height of 1 to 2 inches longer than the unit that will go there. You can install them on the spot with the trelim before screwing each shelf to the side. Ortos each shelf with L-braces. Glue trimma boards to the sides for a smooth surface. If you do this, drill or cut out large holes on one side for power cords to fit through. Paint or bet the TV console table. Allow to dry completely.